Amplitude Modulation MCQ’s

Electronics & Communication Engineering Wireless & Mobile Communications

This set of Wireless & Mobile Communications Multiple Choice Questions & Answers (MCQs) focuses on “Amplitude Modulation”.

1. Modulation index of an AM signal is ratio of __________ to the _______
a) Peak carrier amplitude, Peak message signal amplitude
b) Peak message signal amplitude, Peak carrier amplitude
c) Carrier signal frequency, Message signal frequency
d) Message signal frequency, Carrier signal frequency

2. If the peak message signal amplitude is half the peak amplitude of the carrier signal, the signal is _____ modulated.
a) 100%
b) 2%
c) 50%
d) 70%

3. Carrier signal in modulation technique is _______ signal.
a) High frequency
b) Low frequency
c) High amplitude
d) Low amplitude

4. A percentage of modulation greater than ___________ will distort the message signal.
a) 10%
b) 25%
c) 50%
d) 100%

5. Single sideband AM systems occupy same bandwidth as of conventional AM systems.
a) True
b) False

6. The RF bandwidth of AM is ____________ the maximum frequency contained in the modulating message signal.
a) Equal
b) Two times
c) Four times
d) Ten times

7. How is the performance of SSB AM systems in fading channels?
a) Poor
b) Best
c) Good
d) Average

8. FFSR in AM systems stands for ________
a) Feedforward signal regeneration
b) Feedbackward signal regeneration
c) Feedbackward system restoration
d) Feedforward system restoration

9. Which of the following is a disadvantage of tone-in-band SSB system?
a) High bandwidth
b) Bad adjacent channel protection
c) Effects of multipath
d) Generation and reception of signal is complicated

10. AM demodulation technique can be divided into _____ and _____ demodulation.
a) Direct, indirect
b) Slope detector, zero crossing
c) Coherent, noncoherent
d) Quadrature detection, coherent detection

11. A product detector in AM systems is also called ___________
a) Envelope detector
b) Differentiator
c) Integrator
d) Phase detector

12. Non coherent detection requires the knowledge of transmitted carrier frequency and phase at the receiver.
a) True
b) False

13. AM system use only product detector for demodulation. They never use envelope detectors.
a) True
b) False

Leave a Reply

Your email address will not be published. Required fields are marked *