Designing Shift Registers with VHDL MCQ’s

Electronics & Communication Engineering VHDL

This set of VHDL Multiple Choice Questions & Answers (MCQs) focuses on “Designing Shift Registers with VHDL”.

1. In serial input serial output register, the data of ______ is accessed by the circuit.
a) Last flip-flop
b) First flip-flop
c) All flip-flops
d) No flip-flop

2. In PIPO shift register, parallel data can be taken out by ______
a) Using the Q output of the first flip-flop
b) Using the Q output of the last flip-flop
c) Using the Q output of the second flip-flop
d) Using the Q output of each flip-flop

3. Shift registers comprise of which flip-flops?
a) D flip-flops
b) SR flip-flops
c) JK flip-flops
d) T flip-flops

4. Four bits shift register enables shift control signal in how many clock pulses?
a) Two clock pulses
b) Three clock pulses
c) Four clock pulses
d) Five clock pulses

5. Transfer of one bit of information at a time is called _______
a) Rotating
b) Serial transfer
c) Parallel transfer
d) Shifting

6. Time taken by the shift register to transfer the content is called _______
a) Clock duration
b) Bit duration
c) Word duration
d) Duration

7. Clock divider slow down the input clock of the shift register.
a) True
b) False

8. In gated D latch, which of the following is the input symbol?
a) D
b) Q
c) EN
d) CLK

9. Shift registers are used to delay the data signal.
a) True
b) False

10. Which register is used in the following code?

library ieee;
use ieee.std_logic_1164.all;
entity shift_siso is
port (Clock, Sin : in std_logic;
Sout : out std_logic);
end shift_siso;
architecture behav of shift_siso is
signal temp: std_logic_vector(7 downto 0);
begin
process (Clock)
begin
if (Clock'event and Clock='1') then
for i in 0 to 6 loop
temp(i+1) <= temp(i);
end loop;
temp(0) <= Sin;
end if ;
end process;
Sout <= temp(7);
end behav;

a) Serial in serial out
b) Serial in parallel out
c) Parallel in parallel out
d) Parallel in serial out

Leave a Reply

Your email address will not be published. Required fields are marked *