Limiting and Clamping Circuits and Some Special Types of diodes MCQ’s

Electronic Devices & Circuits Electronics & Communication Engineering

This set of Electronic Devices & Circuits Multiple Choice Questions & Answers (MCQs) focuses on “Limiting and Clamping Circuits and Some Special Types of diodes”.

1. The V0 vs VI curve for the below circuit is

electronic-devices-circuits-questions-bank-q2
electronic-devices-circuits-questions-bank-q2a

a) 

electronic-devices-circuits-questions-bank-q2b

b) 

electronic-devices-circuits-questions-bank-q2c

c) 

electronic-devices-circuits-questions-bank-q2d

d) 

2. For the circuit and the input signal shown which of the following is true for the output voltage?

electronic-devices-circuits-questions-bank-q3

a) The output waveform is a square wave with lowest peak clamped to 0V
b) The output wave is a square wave with lowest peak clamped to -6V
c) The output waveform is a square wave with highest peak clamped to 4V
d) The output waveform is a straight line with the value of output voltage equal to 10V

3. Which of the following circuits can be used as limiter or clamper or both?

electronic-devices-circuits-questions-bank-q1

a)

electronic-devices-circuits-questions-bank-q1a

b)

electronic-devices-circuits-questions-bank-q1b

c)
d) All of the mentioned

4. Which of the following is not true for the duty cycle of a waveform?
a) Duty cycles can be used to describe the percent time of an active signal in an electrical device
b) Duty cycle can be used to determine the percentage of the time a signal is active
c) 60% duty cycle means that the waveform is active for 40% of the total time
d) 50% duty cycle means that the waveform is non-active for 50% of the total time

5. Limiting and clamping circuits are employed in
a) FM transmitters
b) Television receivers and transmitter
c) Production of various signal waveforms such as trapezoidal, square or rectangular waves
d) All of the mentioned

6. Photodiodes are part of
a) Optoelectronics
b) High Intensity Discharge
c) Low pressure Discharge
d) None of the mentioned

7. The maximum and the minimum voltage across the diode D1 respectively is

electronic-devices-circuits-questions-bank-q5

a) 2Vp and 0V respectively
b) 0V and -2Vp respectively
c) Vp and -Vp respectively
d) 2Vp and Vp respectively

8. Which of the following is not true for a Schottky-Barrier Diode (SBD)?
a) It is formed by bringing metal into contact with a moderately doped n-type semiconductor material.
b) In the SBD, current is conducted by mainly by minority carriers.
c) The forward voltage drop of a conducting SBD is lower than that of a pn-junction diode.
d) SBD are used in the design of a special form of bipolar-transistor logic circuits

9. Which of the following is true for LEDs
a) The light emitted by a LED is inversely proportional to the current flowing through the diode
b) LED operate in a manner opposite to the working of the optoelectronics or photodiodes
c) LED cannot be used to generate coherent source of light
d) None of the mentioned

10. Optoisolator is
a) A combination of LED and varactor in the same package
b) A combination of a varactor and photodiode in the same package
c) A combination of LED and a photodiode in the same package
d) A combination of photodiode and Schottky-Barrier Diode in the same package

Leave a Reply

Your email address will not be published. Required fields are marked *