Limits of Operation MCQ’s

Analog Electronic Circuits Electronics & Communication Engineering

This set of Analog Electronic Circuits Multiple Choice Questions & Answers (MCQs) focuses on “Limits of Operation”.

1. What is the region on the output characteristics below IC = ICEO line called?
a) Active region
b) Cutoff region
c) Saturation region
d) Active & Saturation region

2. What is the region on the output characteristics for VCE < VCEsat called?
a) Active region
b) Cutoff region
c) Saturation region
d) Active & Cutoff region

3. For a BJT, what is typically the shape of the power dissipation curve, if it’s plotted on the output characteristics?
a) Parabola
b) Linear
c) Hyperbola
d) Circular

4. From the given characteristics, the value of VCEsat is closest to which of the following values?


a) 0.3 V
b) 1 V
c) 5 V
d) 20V

5. Given that the collector power dissipation is 300 mW, what is the value of collector to emitter voltage for collector current = 50 mA?
a) 6 V
b) 3 V
c) 0 V
d) 2 v

6. If the positive lead of a DMM, with the mode set to ohmmeter is connected to the base and the negative lead to the emitter and a low resistance reading is obtained, then what is the type of transistor that is being tested?
a) NPN
b) PNP
c) Faulty transistor
d) Not a transistor, it is a FET

7. Given that the collector power dissipation is 300 mW, what is the value of collector current for the collector to emitter voltage = 12 V?
a) 50 mA
b) 0 mA
c) 25 mA
d) 100 mA

8. From the given curve tracer response, what is the value of β for IC = 7 mA and VCE = 5 V?


a) 150
b) 180
c) 250
d) 120

9. If the positive lead of a DMM, with the mode set to ohmmeter is connected to the base and the negative lead to the emitter and a high resistance reading is obtained, then what is the type of transistor that is being tested?
a) npn
b) pnp
c) faulty
d) not a transistor, it is a FET

10. For the given transistor, what is the correct sequence of the pins from left to right?


a) ECB
b) BCE
c) CEB
d) CBE

Leave a Reply

Your email address will not be published. Required fields are marked *